Advertisement
Troubleshooting
Problem
The cleaner starts and stops or does not
move.
The cleaner misses spots in the pool.
The cleaner does not rise.
The cleaner is taking too long to climb
walls or get out of the water.
Presence of cleaning sticks in the cor-
ners, under the ladders, under the lights
or on the steps of the pool.
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Proposal for solution
Make sure that filter is clean and pump is switched on.
Switch off safety suction; make sure that main drain is closed.
Make sure that vacuum plate is properly installed.
Check if cleaner and hose are free from air pockets.
Check membrane for damage or blockages.
Make sure that correct amount of hose has been installed; try
adding or removing a length of tubing or two.
Make sure that all returns direct flow of water to pool floor;
adjust balls or use water distributor.
Make sure that hose is straight and not tangled.
Make sure that pool water is properly balanced; a high pH
and/or lack of chlorine make walls very slippery.
Increase suction with flow regulator.
Check that float arm is in correct position. Note: Cleaner can-
not climb up in pools with sharp 90-degree angle between
wall and floor.
Reduce suction power using flow control.
Adjust supplied hose weight towards cleaning head.
Make sure that correct amount of hose has been installed, try
adding or removing a length of tubing or two.
Make sure that all returns direct flow of water to pool floor;
adjust balls or use water distributor.
Add optional hose motors and/or replace wheel deflector with
a larger one.
Item 61947
Page 7
12
2021-1
Advertisement
