Advertisement
Quick Links
Advertisement
Summary of Contents for Alfresco KAKADU 2
- Page 1 KAKADU 2 Assembly Instructions...
- Page 3 KAKADU 2 Content List Carcass Boxes 1 x HN1110DWF (Fridge Unit Cabinet) 1 x HN12502BQ (BBQ Unit Cabinet) 1 x HN11102D (Sink Unit Cabinet) Door Boxes 1 x HN1110DWF – Kicker/Infills 1 x HN12502BQ – Door/Kicker 1 x HN11102D – Door/Kicker...
- Page 5 Carcass Assembly Assemble Fridge Unit Cabinet HN1110DWF as per assembly instructions provided using hardware supplied...
- Page 6 Carcass Assembly Assemble BBQ Unit Carcass HN12502BQ as per assembly instructions provided using hardware supplied...
- Page 7 Carcass Assembly Assemble Sink Unit Carcass HN11102D as per assembly instructions provided using hardware supplied...
- Page 8 Carcass Installation Floor Check Using a spirit level (1200mm min) check the floor where you are planning to install the carcass units. Mark with a pencil indicating the highest and lowest sections of the floor...
- Page 9 Carcass Installation Wall layout Refer to the KAKADU 2 kitchen layout (pg. 2) and mark the cabinetry unit widths and heights making allowance for 20mm thickness of stone. The finished joinery height recommended is 950mm...
- Page 10 Carcass Installation Placement and Connection of Carcass Units Starting with HN1110DWF place the unit in desired position and level off to the recommended height as marked on wall layout allowing 120mm void from the back of the unit to the wall to allow for services void (drill through service point as required) Place HN12502BQ unit in desired position and level off to the recommended height using adjustable legs allowing approx 100mm void from the back of the unit to the...
- Page 11 Stone Top Installation Gluing of Stone Tops Starting with stone pieces A&B place pieces one by one on HN12502BQ allowing 20mm past the front of the carcass. Using neutral cure clear silicone apply 10mm diameter dollops and apply pressure to tops Apply stone piece C to side of HN1110DWF sitting on Stone piece A (silicone off) Apply stone piece D to side of HN11102D sitting on stone piece B (silicone off) Ensure alignment of stone pieces A-D...
- Page 12 Door & Kicker Installation Door Hanging Starting with door pack HN12502BQ screw hinges on the 2 doors using pre-drilled holes and M5 screws provided. Attach doors to clip on plates located on the carcass sides Repeat the above steps for door pack HN11102D Infill Placement Attach infill pieces from door pack HN1110DWF with neutral cure clear silicone and press in position...
- Page 13 Appliance & Accessory Placement Beverage Cooler Unpack and slide EA900WFSX (Beverage Cooler) into HN1110DWF (ready for installation by qualified electrician) Unpack and place HN1200RBQ (6 Burner BBQ Hooded) on to HN12502BQ (ready for installation by qualified gas fitter) Unpack and place EMJG30WSX (Domino Wok Burner) on to HN11102D (ready for installation by qualified gas fitter) Sink &...
Need help?
Do you have a question about the KAKADU 2 and is the answer not in the manual?
Questions and answers