Advertisement
Quick Links
Gold
Series
Before troubleshooting your MegaPeel be sure that
the crystal cannister is
not empty or the waste filter is not full.
TROUBLESHOOTING
We expect that your experiences with the MegaPeel product and process will always run smoothly. In
case you run into problems, here's a handful of suggestions.
WHAT IF THE MACHINE DOES NOT TURN ON?
Make sure that cord in the back is plugged in and the power button on the front of the machine is on.
Check the fuse.
Unplug the machine.
On the back of the machine, right of the circular vent, is the black fuse box.
Use a regular, flat-blade screwdriver to pull out the front of the black fuse box.
Again using the screw driver, pop off the red fuse box. If the fuse looks blown, replace it with a new fuse.
From the spare parts kit, take a new fuse, which is a glass-and-steel tube about 1 1/4-inch long.
Using your fingers, remove the old fuse from the MegaPeel.
Install the new fuse.
Throw the old fuse into regular trash.
WHAT IF CRYSTALS ARE NOT COMING OUT OF THE HAND-PIECE? #1
Remove the lid.
Lift the top of the machine.
Lift the white crystal container (the smaller of the 2 containers) from the machine.
To remove the blue tube, push down with your thumb on the small, white plastic piece located on the
crystal container.
Advertisement
Summary of Contents for DERMAMED Gold Series
- Page 1 Gold Series Before troubleshooting your MegaPeel be sure that the crystal cannister is not empty or the waste filter is not full. TROUBLESHOOTING We expect that your experiences with the MegaPeel product and process will always run smoothly. In case you run into problems, here’s a handful of suggestions. WHAT IF THE MACHINE DOES NOT TURN ON? Make sure that cord in the back is plugged in and the power button on the front of the machine is on.
- Page 2 Take the short blue tube from the spare parts kit. Attach it to the metal grommet at the end of the long, blue crystal tube. Press on the pink O-ring to remove the pink tube attached to the waste container from the machine.
- Page 3 Gold Series Pull out the tubes. Take the clear, 5-inch, U-shaped tube from the spare parts kit and connect it to the O-rings on the front of the machine .The tube will look like a horseshoe in the front of the machine. Turn the vacuum knob all the way to the right so the vacuum is at its highest pressure.
- Page 4 Attach it to the metal grommet at the end of the long, blue crystal tube. Press on the pink O-ring to remove the pink tube attached to the waste container from the machine. Attach the pink tube from the waste filter to the other end of the short blue tube from the spare parts kit which is already connected to the blue tube coming out of the machine.
- Page 5 Run the system for several minutes in the morning before replacing the crystal canister. This will introduce dry air into the system. If after doing all the above clearings and crystals are not coming out of the hand-piece, call DermaMed’s Technical Support line, 610.358-4447. We will help you make the machine work properly.