GearLight S300 Operation Manual

TROUBLESHOOTING
If the light does not turn on or works intermittently:
Make sure the power button is not stuck.
Recharge the light only if no damage is observed.
If the light does not charge:
Check the USB charging cable connection and the power source.
Note: A computer in sleep mode will not charge the light.
If the problem persists: Replace the USB charging cable.
If the headlight mount will not hold:
Tighten the mounting screw. Make sure at least one of the two rubber strips is
located between the handlebar and the mount.
MAINTENANCE
When the lights are not in use, store them with a moderate level of charge and in a
cool place away from flammable materials. Once every few months, discharge
the batteries fully and recharge.
WARRANTY AND LIMITATION OF LIABILITY
Limited One-Year Warranty
GearLight warrants this product for one year from the date of purchase
against any defects in material or workmanship. This warranty does not cover
normal wear and tear, nor damage resulting from misuse or neglect. We will,
at our discretion, repair, replace, or refund the purchase price of this product
should we determine it to be defective.
Limitation Of Liability
Liability limited to the purchase price of this product. GearLight shall not be
liable for any incidental or consequential damages or any implied warranty on
this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
Irvine, California | USA | www.GearLight.com
S300 RECHARGEABLE LED BIKE LIGHT SET
Operation Guide
FOR YOUR SAFETY READ BEFORE OPERATING
Press & hold
the power button
for 2 seconds to
turn on taillight.
Package Contents:
1x GearLight S300 Rechargeable LED Headlight
1x GearLight S300 Rechargeable LED Taillight
2x USB Charging Cables
1x Operation Guide
V2
1x Warranty Card