Advertisement
Quick Links
Advertisement
Summary of Contents for Ultraframe Gardenrooms The Studio
- Page 1 The Studio Installation Guide Version 1.0 Gardenrooms By Ultraframe...
- Page 2 Personal Protective Equipment - such as goggles, mask and ear defenders – should be used when appropriate. Careful consideration should be given to the safe disposal of all packaging - Ultraframe packaging is predominantly made from recycled materials and can be readily recycled.
- Page 3 Component Identification Component Identification...
- Page 4 Fixings Identification Installation Lay out the DPC roll around the perimeter of the Evenly position cill on slab/base sealing any Measure back from the internal frame (this base where walls are to be positioned, aligning joints with an appropriate sealant. Check level datum is provided by the cill) by 189mm to the to the outside edge.
-
Page 5: Installation
PROPERTY RIGHTS IN & TO THE DESIGNS & INFORMATION & ANY CHANGES screws (CHAA006). tacks into the corner columns. Repeat across THERE TO & DEVELOPMENTS THERE OF BY ULTRAFRAME OR ANY THIRD PARTIES through, measure the diagonals to ensure SCALE:... - Page 6 Installation Installation Remove Area Secure these cleats in place using (CRN006) Fix the small cornice returns to the columns Silicone seal front and back edge of lower Prepare the two eaves beam end caps as Apply silicone to all four eaves end caps and Apply sealant along the top of the firings.
- Page 7 Installation Installation For 6000 width Garden Room only: Slide down LANCS090 upper corner cover so Whilst ensuring the corner remains in position, Place the aluminium top caps onto a protected Position bar top cap. Using the heel of your Prep the gable cloaking trim with the detail Whilst ensuring that the joint remains located bracket cleats slot into top section.
- Page 8 Installation Installation For Garden Room with glazing only: Position corner against column ensuring it is Run a continuous bead of sealant along the Fit powder coated infill panel into one side Fit end profile to modesty panel. This end Sit modesty panel inbetween the bars of the The frame, previously constructed, should sit a good tight fit against the underside cornice/ corner claddings and the cladding clips as...
- Page 9 Job No.: 7097 GRIGS001 05/21 v1 It is Ultraframe’s policy to continually seek to improve its products, processes and services, and we reserve the right to change specifications without prior notice. Ultraframe is a trading name of Ultraframe (UK) Limited.
Need help?
Do you have a question about the Gardenrooms The Studio and is the answer not in the manual?
Questions and answers