Dish Network DISH 500 Manual page 6

Dish Antennas - DISH 1000.2
DISH 1000.2 (continued)
Three-LNBF Bracket
• The Three-LNBF Bracket uses three Singles/Duals and a switch.
The W-Bracket from the DISH 1000 is not interchangeable with the
Three-LNBF Bracket.
• You cannot use a Twin/Quad LNBF with the Three-LNBF Bracket.
• Do not mix Legacy and DP/DPP LNBFs and switches.
Additional Installation Considerations
• Additional skew holes are provided on the skew plate for increased stability at
extreme skew angles (greater than 110 or less than 70).
• After peaking on 119°, confirm signal strength on 110° and 129°.
• The following Legacy receivers do not have 129° software support: Models 1000, 3000, 4000, 5000, JVC-DVHS (IRR),
and DishPlayer 7100/7200.
• Mast uses a heavier gauge steel and is slightly longer than DISH 1000, but has the same outside diameter. Only the
DISH 1000.2 mast/foot assembly should be used with the DISH 1000.2 reflector.
• Antenna dimensions: 25.9"W x 20.7"H.
Three-LNBF Bracket
2 - 6