Contents Before using the device ........................4 Intended use ............................4 For your safety ..........................4 - 5 Signal symbols ..........................4 General safety instructions ....................... 4 4 - 5 Safety instructions ........................Before first use ............................. 5 Assembly ............................5 - 7 Preparation ............................
Before using the product Safety instructions After unpacking and before use, check the product for damages. Danger Risk of electric shock ! Should the product be damaged, do not use it and contact your This device is an electrical appliance for domestic retailer.
– Never touch the device after it has fallen into water. Switch Danger Hazards for children! off the power supply and pull out the power plug. Do not use Children may become entangled in packaging foil the device again until it has been checked and approved by a and suffocate.
Assembling the patio heater Step 1 Insert the power cord through the base and the lower pipe, and pull-out approx. 1.8M (measuring the length from the middle hole of the base to the plug). Fasten the cable with two medium-sized screws. . Step 2 Connect the lower pipe and bottom plate with 3 large screws.
Page 7
Step 3 Connect the middle pipe and upper pipe. Step 4 Connect the power cord plug to the socket in the heater head. Place the heater head on top of the pipes and fix it with small screws. The patio heater is now fully assembled and can, if necessary, mportant: All screws must be tightened securely.
Technical Data Attention Risk of damage! During use, the screws can loosen slowly and impair Product: Item. No. 2141 "Millbury" the grill‘s stability. Outdoor patio heater – Check that all screws are tightened before use. If necessary, approx. 13 kg Weight: tighten all screws to guarantee stability.
Need help?
Do you have a question about the MILLBURY and is the answer not in the manual?
Questions and answers