Titon Overture DH Fixing And Operating Instructions

Diagram
Supplied with:
1 shafts 108mm
1 shaft 95mm
2 screws M5 85mm long
2 screws M5 75mm long
TN8100 & TN8104
(Lever/Lever)
Routing / Drilling Detail
Page 1 of 3
All manuals and user guides at all-guides.com
Fixing Instructions
1. Rout / drill door.
2. Cut screws (M5) and spindles (8mm Square) to length if
3. Place spindles in position
4. Place both handles into position and insert and tighten
Supplied with:
5. Fit Euro cylinder and tighten handle fixing screws, do not
1 shafts 108mm
2 screws M5 85mm long
2 screws M5 75mm long
TN8101 & TN 8105
Cleaning
(Lever/Pad)
Door handles should only be cleaned using warm soapy water
and a soft cloth.
Do not clean any part with solvents or abrasive substances.
Failure to adhere to these instructions invalidates your Titon Product Guarantee.
Paint or corrosion not covered by Guarantee.
Fixing and Operating Instructions
Overture DH - Short Base Plate
necessary.
fixing screws, leaving loose.
over tighten.
BM484 Iss01 © 2014