AIS RS-109M Operating Instructions

AIS Net Locator operating
instructions

Unpacking and inspection

Please unpack the product properly and take an
inventory of the accessories according to the
table below. It is recommended that you keep the
box and packaging materials.
Item Count
Net Locator 1 Manual
Power adapter 1

Main features

GPS/BeiDou dual-mode precise
•
positioning, with the possibility of
displaying the position of the N et Locator
on the AIS receiver
Display of the Net Locator 's power status
•
on the AIS receiver
AIS signal transmission interval
•
configurable : 0.5 minutes - 10 minutes
Waterproof rating: IPX7.
•
Can work continuously for more than 15
•
days on one charge (transmitting interval
set to 3 minutes)
Easy bundling and convenient operation
•
for switching on and off

Overview

1. Built-in antenna
2. Transparent bottom cover
3. Programming interface
Item Count
4. Charging port
1
5. Power switch
6. Charging indicator (red
7. Working light (red and
Notes
The programming interface is used to set the
ship name, MMSI code, transmit interval time, call
sign and other extended information. To be set by
the dealer only.
No attempt should be made to remove the panel
of the N et Locato r as this will cause a leak!
and yellow)
green)

Charging the battery

Before use, the battery should be charged.
Plug the power adapter into the AC power output
socket.
Unscrew the transparent bottom cover on the
underside of the Net Locator .
Remove the plug of the charging port on the
panel of the Net Locator and plug the output
terminal of the power adapter into the charging
port to start charging.
When the battery is fully charged, the yellow light
will be illuminated. Charging time is approximately
4 to 5 hours.
After charging, the transparent bottom cover
should be screwed on tightly to ensure water
resistance.
Notes
When charging, please turn the power switch to
OFF (power off).
Do not short-circuit the charging connector.
Use a dedicated power adapter (DC 9.2V / 1A
output), otherwise the unit may be damaged.