Venset 905 Instruction

Instruction for Remote system
Article no.: 905 + 906
Installation
connect the power supply and the motor unit to the remote receiver. 2 different plug sizes
o
make this connection only possible to make in the right way
after having connected the plugs, the blue light will be lightning
o
push the emitter buttons and the motor unit will open and close
o
for stopping the motion one of the buttons need to be pushed
o
Learning
if the remote receiver do not respond when pushing the emitter buttons, reset the receiver and
o
follow the instruction below
push the learner button on the receiver for less than 1 sec.
o
push one of the emitter buttons
o
the red LED light will start flashing
o
push one of the emitter buttons again and the red light will turn off
o
the units now are coded together with a unique code
o
Reset
push and hold down the learner button on the receiver for 10 sec. (will be reset when the red
o
light turns off).
Trouble Shooting
check the plug connections
o
check whether the blue light is on
o
reset the receiver and make a new coding
o
Copyright 2005, VenSet A/S, VenSet
®
is a registered trademark