Advertisement
Operating Your Juicer
Before the first use clean top lid, large and small cone, upper and lower sieve and cup
thoroughly under warm water.
1. Place the cup on the power base, turn the cup in clockwise until it clicks into place, then
assemble the upper sieve or upper and lower sieve into the rotating axis. When using the two
sieves together, first place the lower sieve then assemble the upper sieve, make the knob on the
lower sieve come out from the hole on the upper sieve, Turning the knob on the handle toward
left would reduce the sieve hole as illustrated in fig.1. To enlarge the holes, turn the knob in
opposite direction. You may also use only the Upper sieve separately.
2. Use the appropriate cone according to the fruit size. Small fruit can be squeezed on the smaller
cone, while for the large size fruit both the cones have to be used together i.e. the large cone put
on top of the small cone.
3. Plug the power cord into the outlet; turn the knob to select desired size of hole, to control the
flow of juice.
4. Halve the fruit, put the fruit on the cone and press it lightly, the motor will start running, then the
extracted juice will start flowing into the cup through the sieve, the roughness flesh and pith will
remain on the sieve. The motor may rotate in either direction.
Caution: Never exert excessive force when pressing the fruit to prevent from blocking
and damaging the motor.
5. Once completed the squeezing, release the hand from the cone and the motor will stop running,
the appliance now is in the idle state. You may restart it again at any time by pressing the cone
down..
Caution: The appliance shall be ON 15seconds, OFF 15seconds, and after 10 consecutive
cycles, the appliance must not be used for 30 minutes to let it cool down.
Note: The Max capacity of the cup is 1L, To avoid the spillage do not fill the cup above the
maximum level.
6. Make sure to Unplug the appliance after each use & also when not in frequent use.
7. While pouring the juice in the cup, make sure the top lid is in place. To not let the juice spoil, do
not keep the juice in the cup for longer time.
8. The power cord can be wrapped around the groove on the power base for easier storage when
not in use. Also the plug can be embedded into the bottom of base unit as illustrated in fig.2.
Cleaning and Maintenance
1. Unplug the appliance and wait till it completely cools down, before cleaning.
2. Disassemble the sieves, large and small cone, top lid and cup. Clean them in hot water. Then
rinse under running water and wipe it to dry. Please note it is not Dishwasher proof.
Caution: Never use metal polish for cleaning and do not put into dishwasher to clean.
3. Wipe the rotating axis with a soft, damp cloth, Do not immerse the power base in water or any
other liquid.
4. Assemble back all the parts together.
Fig.1
2
Fig.2
Advertisement
