Advertisement
Quick Links
Advertisement
Summary of Contents for Blue Wave FlowXtreme NS1002
- Page 1 FX Flat Panel Solar Heater - 21' Pool Manual VER.0418 NS1002...
- Page 2 A.Safety instructions Read through these instructions carefully before you use the product. Caution: Failure to comply fully with our instructions for use, or safety instructions, may cause damage or injury to individuals. Please read the instruction manual and the directions shown there. ...
-
Page 3: Installation Instructions
an area protected from freezing. The solar heater should be removed before the first frost, or at the end of the pool season. All parts must be rinsed or cleaned with water only. Detergents may damage the protective cover. 6. Storage Drain all the water from the solar heater by closing off the pipes. - Page 4 F. Initial use Once the solar heater is assembled and the hoses are connected to the filter pump and the pool, open the water supply and ensure that water is flowing through the hose. Then turn on the filter system. Air bubbles will rise from the inlet nozzle in the pool. This happens as the air is expelled from the solar heater.
- Page 5 H.Installation Figure Figure 1 I . NS1002 FX Flat Panel Solar Heater Parts Breakdown Part Name BW SKU For Model # Kappa Solar Panel NUP4061 NS1002 Leg Brace NUP4062 NS1002 Flat Gasket NUP4063 NS1002 32mm ose Connector NUP4064 NS1002 Connector Cap NUP4065 NS1002 Hose Reducer...
- Page 6 a. Connection for 1¼” or 1½’’Diameter Unthreaded Hoses b. Connection for 40mm Diameter Intex® Threaded Hoses...
Need help?
Do you have a question about the FlowXtreme NS1002 and is the answer not in the manual?
Questions and answers