Advertisement
Step 1: Station Setup
1) Remove station from the box and position it sink-side down on the ground so that the support
legs are accessible.
2) Find the outermost leg assembly, and pull outward from the rubber foot end. The leg assembly
will unfold until it is at a right angle to the station.
3) You will find two support struts where the leg assembly meets the table. Make sure that both
are locked completely straight to ensure the stability of the station.
4) Repeat this same process with the innermost leg assembly.
5) Once complete, flip the entire station upside down so that both sets of feet are resting on the
ground and the sink side is now facing upward.
Step 2: Faucet Assembly
1) Take out the whole faucet and count all components.
2) Put the faucet
thread through the steel cover
1
hole
in the table .
4
3) Attach the rubber washer
4) Screw the pipe connection
5) Connect the water hose to the pipe connection .
MULTI-USE OUTDOOR TABLE
SETUP INSTRUCTIONS
to the faucet
thread, then screw the plastic thread joints
5
1
with the two black washers (
8
and rubber washer , then insert into the
2
and
) to the faucet
7
9
8
18200
3
tightly.
6
tightly.
1
Advertisement
Table of Contents
Summary of Contents for High-Desert 18200
- Page 1 18200 MULTI-USE OUTDOOR TABLE SETUP INSTRUCTIONS Step 1: Station Setup 1) Remove station from the box and position it sink-side down on the ground so that the support legs are accessible. 2) Find the outermost leg assembly, and pull outward from the rubber foot end. The leg assembly will unfold until it is at a right angle to the station.
- Page 2 Step 3: Drainer Assembly 1) Assemble the drain pipe with the thread joints and washer by screwing. 2) Twist the screw through the steel plate , large black washer and the table sink hole . 3) Attach the assembled drain pipe ( , ) to the screw and twist tightly.
Need help?
Do you have a question about the 18200 and is the answer not in the manual?
Questions and answers