Advertisement
STEP 3
STEP 4
STEP 5
Plug in speaker to output 1 or 2, they are
both the same, both jacks are in parallel.
NOTE: For speaker setup click on
"Troubleshooting" and "Speakers".
IMPORTANT: Do NOT turn on the
amplifier without a speaker plugged in!
Make sure the OHM setting is correct.
Improper setting will result in damage to
the amp!
NOTE: On the back is where you will
find the OHM setting, make sure the
speaker matches the OHM setting.
Set the switch in the back to 50W.
NOTE: This step is very important, if
you don't set this to 50W setting you will
not get the correct bias setting when you
adjust it later in the procedures.
- 3 -
Advertisement
