Related Manuals for Lanpro LP-1520ai
Summary of Contents for Lanpro LP-1520ai
- Page 1 Wireless - Equipment 123 Manual for the Installation of the LP-1520ai as a Universal Repeater. LP1520ai_M123_ENG01W 123 Manual for the Installation of the LP-1520ai as a Universal Repeater. www.lanpro.com...
- Page 2 Please take in mind if you have MAC or IP access control in the router or AP you wish to repeat the signal from. In this configuration, the LP-1520ai will be a client of the network you wish to repeat and an additional Access point of the selected wireless network.
- Page 3 Select option: TCP/IP Settings, LAN Interface and in the DHCP field select: Disabled. Then select: Apply changes, as shown in figure 4. (Remember to verify that the LP-1520ai’s IP address is not being used in the network to which you will connect to, we recommend to use an IP address inside the destination network so it can be managed).
- Page 4 You will now configure the wireless network security in case the destination router has it enabled. Always remember then in this configuration, the LP-1520ai behaves as a client of the destination router. Please configure its security as if it were another client of this network.
- Page 5 Select: OK as shown in figure 8. Figure 8 The equipment will reboot now. Once the configuration has been done, the LP-1520ai will automatically connect even though you disconnect it and connect it again. Highly Recommended: As shown in figure 9, proceed to change the Administration Password of your equipment. In order to do this action, select: Management, then: Password.