ProSoft Technology PLX51-DLplus-232 Quick Start Manual

Hide thumbs Also See for PLX51-DLplus-232:

Advertisement

PLX51-DLplus-232 Quick Start Guide
Note: Before installing, configuring, operating, or maintaining ProSoft Technology products, please review this information and
the information located on
www.prosoft-technology.com
your ProSoft Technology product.
Installation and maintenance of your ProSoft Technology product(s) should be carried out by suitably trained personnel in
accordance with applicable codes of practice. In case of malfunction or damage, no attempts of repair should be made. Your
ProSoft Technology product(s) should be returned to the manufacturer for repair. Do not dismantle the product.
Your Feedback Please
We always want you to feel that you made the right decision to use our products. If you have suggestions, comments,
compliments or complaints about our products, documentation, or support, please write or call us.
ProSoft Technology, Inc.
+1 (661) 716-5100
+1 (661) 716-5101 (Fax)
www.prosoft-technology.com
support@prosoft-technology.com
September 30, 2019
®
ProSoft Technology
, is a registered copyright of ProSoft Technology, Inc. All other brand or product names are or may be
trademarks of, and are used to identify products and services of, their respective owners.
Documentation is subject to change without notice.
For professional users in the European Union
If you wish to discard electrical and electronic equipment (EEE), please contact your dealer or supplier for further
information.
WARNING – Cancer and reproductive harm –
North American Hazardous Location Approval
The following information applies when operating the product in hazardous locations:
THIS EQUIPMENT IS AN OPEN-TYPE DEVICE AND IS MEANT TO BE INSTALLED IN AN ENCLOSURE SUITABLE FOR
THE ENVIRONMENT SUCH THAT THE EQUIPMENT IS ONLY ACCESSIBLE WITH THE USE OF A TOOL.
SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C AND D HAZARDOUS LOCATIONS, OR NONHAZARDOUS
LOCATIONS ONLY.

Required Software

The PLX51-DLplus-232 requires the ProSoft PLX50 Configuration Utility to setup and configure. The software installation can
be found at:
www.prosoft-technology.com
ProSoft Technology, Inc.
for the latest software, documentation, and installation files specific to
www.p65warnings.ca.gov
Page 1 of 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PLX51-DLplus-232 and is the answer not in the manual?

Questions and answers

Summary of Contents for ProSoft Technology PLX51-DLplus-232

  • Page 1 ® ProSoft Technology , is a registered copyright of ProSoft Technology, Inc. All other brand or product names are or may be trademarks of, and are used to identify products and services of, their respective owners. Documentation is subject to change without notice.
  • Page 2 PLX51-DLplus-232 Quick Start Guide Module Installation The PLX51-DLplus-232 requires input power of 10 to 32 VDC. It communicates on both Ethernet and RS232 serial. Below are the side and bottom views of the module: Ethernet Network Setup The PLX51-DLplus-232 has DHCP enabled as factory default. Launch the DHCP server for the ProSoft PLX50 Configuration Utility to assign an IP address to the module.

Table of Contents