Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Teledyne Lecroy OC1021-A
- Page 1 OC1021-A Instrument Cart Assembly Instructions and User’s Manual PN LEC4450 Rev A...
- Page 2 4 Set Screws Small Hex Wrench (1/8) 1 Retaining Bar 2 Wing Nuts 2 Long Screws Large Hex Wrench (5/32) 14 Short Screws 1 Top Shelf 4 Small Screws 2 Knobs 2 Posts 2 Shoulder Screws 6 Plastic Washers 1 Bottom Tray 6 Rods 16 Large Lock Washers...
- Page 3 Note: Correct installation of Set Screw and Long Screw necessary for proper performance of cart.
- Page 4 Small Wrench 2 Metal Washers 2 Knobs 6 Plastic Plastic Washer Washers 4 Set Screws Plastic Washers 2 Rods 2 Shoulder Screws Metal Washer Illustration 1: Loosely preassemble 2 Rods and all Shoulder Screws, Knobs, Plastic Washers, and Metal Washers to the Top Shelf using the placement as shown.
- Page 5 Large Wrench 4 Short Screws 2 Rods 4 Large Lock Wash- Illustration 4: Loosely preassemble the Support Bar, Short Screws, Rods and Large Lock Washers as shown. Illustration 5 and 6: Orientate the Support Bar to the Top Shelf using the two slots as shown, and slide it a few inches below the Top Shelf.
- Page 6 Small Wrench 4 Small Lock 4 Small Washers Screws Illustration 7 and 8: Firmly tighten the Leg to the Bottom Tray with the Small Screws and Small Lock Washers as shown.
- Page 7 Large Wrench 2 Large Lock Washers 2 Rods 2 Long Screws Illustration 9: Loosely preassemble the two Long Screws and two Rods with Large Lock Washers to the Legs. Illustration 10: Orient the nonlocking caster and the slots in the Top Shelf and slide the Leg and Tray Assembly onto the Posts. Illustration 11: Fit the Long Screws into the mating hole inside the Posts, lightly tighten the screw ensuring it has correctly engaged the hole.
- Page 8 Large Wrench 15.5” Small Wrench 10 Large Lock Wash- 10 Short Screws Illustration 12: Firmly tighten the 4 Short Screws and Large Lock Washers into the Bottom Tray as shown. Illustration 13: Firmly tighten the 6 Short Screws and Large Lock Washers into the Legs as shown. Illustration 14: Carefully stand the cart upright as it will sway somewhat.
- Page 9 Slots 2 Wing Nuts 2 Straps Illustration 15: The Retaining Bar attaches to the Top Shelf in one of two places. Measure the scope from the front to the front most feet and firmly tighten the bar in the appropriate position with the Wing Nuts. Strap the scope to the cart using the front most slot and one of the two rearmost slots on the Top Shelf.
Need help?
Do you have a question about the OC1021-A and is the answer not in the manual?
Questions and answers