Jysk CHRISTIAN Assembly Instructions

Before you begin, ask an Adult to set-up your lamp by doing
the following:
1. Remove the lamp from the packaging.
2. Set the lamp base on a flat floor, away from any flammable
materials. Screw the pole 1 to the base, screw the pole 2 to
the pole 1, screw the pole 3 to pole 2, screw the pole 4 to
pole 3.
3. Insert a E26 25 Watt (Maximum) standard/ frosted regular
lightbulb (not include) in to the lamp socket by turning it
clockwise.
NOTE: DO NOT over-rotate the bulb as it may shatter and
cause bodily injury.
4. Plug the lamp into a nearby 120 AC wall outlet.
5. DO NOT stretch the cord across areas where people walk.
6. DO NOT allow children, adults or pets in areas in which the
lamp can accidently pulled off the table.
7. Switch the lamp ON.
E26 25
25
WARNING: To reduce the risk of burns, fire,
electric shock or injury to persons, this furnishing
has a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet.
Do not change the plug in any way.
CAUTION:
TO REDUCE THE RISK OF FIRE -
USE 25 WATT OR SMALLER,
VOLT, TYPE LAMP(S)
L
N
N