Polar Electro Polar Heat C1 User Manual

Heater control panel

Advertisement

Quick Links

C1 Heater Control Panel User Manual

1. Introduction

Please read these operating instructions carefully before starting to set up and operate. This
operating manual contains all the important information you need during setup and operation.
Please keep this operation manual for future reference.

1.1 Safety instructions

When entering the gas station, be sure to turn off the heater. Pay attention to all information
and tips, especially the safety instructions in this document and heater instructions!

1.2 Scope of use

The timer is used to start and switch off the heater equipment installed in the vehicle, as well
as for selecting the operating mode, setting the operating time and pre-selecting the start time.

1.3 General tips

The timer has a simple operating structure. All functions must be set and changed when
required by means of 4 buttons.
If the car has been disconnected (the battery has been disconnected) and then the power is
restored, the time and day of the week have to be set again.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Polar Heat C1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Polar Electro Polar Heat C1

  • Page 1 C1 Heater Control Panel User Manual 1. Introduction Please read these operating instructions carefully before starting to set up and operate. This operating manual contains all the important information you need during setup and operation. Please keep this operation manual for future reference. 1.1 Safety instructions When entering the gas station, be sure to turn off the heater.
  • Page 2 2. Overview 2.1 Technical Parameters Rated Voltage Operating Voltage Range 9V - 18V Operating Temperature -40℃ - +65℃/-40℉ - +149℉ Installation Location Vehicle Interior Timing Start start times can be preset within 7 days 2.2 Key Description Off State Left /Down Key Right/Up Key On/Off/Confirm Key Return Key...
  • Page 3 3. Operation & Setting 3.1 ON/OFF Power on: Press any key to wake up the screen, short press the power on key to enter the running time adjustment interface. Adjust the running time according to different needs, press the left key to reduce the running time, press the right key to increase the running time.
  • Page 4 enter the time setting (24 hours). After pressing confirm key the clock flashes, press left and right key to adjust the clock. After pressing confirm key, the minute flashes, press left and right key to adjust the minute. Press confirm button again to return to clock screen. Press left and right button to select week setting, press confirm button to enter week setting screen, press left and right button to select week (MON.TUE.WEN.THR.FRI.SAT.SUN.).
  • Page 5 4 Faults & Solutions 4.1 Error Code Error Error of Issue Troubleshooting Code E-01 The heater failed to Two ignition failures, check the oil circuit and intake and ignite exhaust. Flame goes out The flame goes out during operation, check the oil E-02 circuit.

Table of Contents