AudioRange SPK-1000FM Manual

Important Safety Instructions

Please read these safety instructions carefully before using your AudioRange SPK-1000FM

This device is intended for home and personal use only.

Keep the device dry and away from water. Water may damage the device.

Do not open the unit or battery. Opening the battery compartment voids this product's warranty.

The wireless TV speakers use a lithium-ion battery. Do not burn or place used batteries/devices

in household trash.

Do not pull on the cord to unplug this device, doing so may damage the cord.

The device should not be used if damaged or malfunctioning.

Make sure the device is unplugged when cleaning.

WARNING: Consult your doctor or physician if you have a pacemaker before using

Plug the AC adapter into the base. The base's front power

indicator light will turn on once it's connected.

Place the wireless speaker on the base.

A red LED will ﬂash as the speaker charges.

Allow at least 6 hours to charge.

Locate audio connections on the back or

side of your TV.

If you are using the 3.5mm headphone

STEP 1a.

connection please start with

If you are using the 3.5mm headphone

connection with the RCA adapter

please start with

STEP 1a.

If you are using Optical connection

STEP 1b.

please start with

Table of Contents

Do you have a question about the SPK-1000FM and is the answer not in the manual?

michael hardoby Jr

May 19, 2025

it does not hold a charge longer than an hour. does that mean the battery must be cghanged

1 comments:

Mr. Anderson

May 23, 2025

Yes, if the AudioRange SPK-1000FM does not hold a charge longer than an hour, it likely needs a battery replacement.

This answer is automatically generated

Page 1 Plug the AC adapter into the base. The base’s front power Important Safety Instructions indicator light will turn on once it’s connected. Please read these safety instructions carefully before using your AudioRange SPK-1000FM Place the wireless speaker on the base. This device is intended for home and personal use only.
Page 2 Installation using ANALOG Outputs Installation using DIGITAL Outputs STEP 1a: STEP 1b: Turn on TV. Turn on TV. Option 1: Plug the 3.5mm in-line jack into Plug the optical cable* into the TV the TV. Then plug the opposite end into and base.
Page 3 STEP 2 STEP 3 Turn on the wireless speaker by rotating Rotate the mode switch to 2.4G on the the on/oﬀ volume control knob on the front of the speaker to connect to the TV. front of the speaker. Once the indicator light is on, proceed to Step 4.
Page 4 STEP 4 You have now successfully set up your Audiorange SPK- 1000FM. IMPORTANT: If you cannot If you cannot hear any sound: access your TV’s audio Increase the volume on the wireless speaker with the settings, please refer to your on/oﬀ...