Page 1
REMOTE PROGRAMMING & OPERATION INSTRUCTIONS For: Thunder Electric Tarp System EZ Flow Hydraulic Trap System EZ Flow Hydraulic Trap & Hatch System For Roughneck Trailers Remote Lift Axle System 3400 West O Street Lincoln, NE 68528 402-435-4249 (Fax) 402-438-3918 www.thunderstonemfg.com April 18 2020...
Page 2
Programming Remote to work with the Thunder Electric Tarp System Open & Close Power on the keypad controller on the front of the trailer by holding the Buttons “Open” and “Close” buttons on the keypad simultaneously for 5 seconds or until the white light illuminates to indicate the system is active. KEYPAD Open the lid on the flip style remote and observe the buttons illuminate indicating the remote is active.
Page 3
Programming Remote to work with the EZ Flow Trap System Status Power on the keypad controller on the trailer by holding the “FRONT OPEN” and “FRONT CLOSE” buttons on the KEYPAD keypad simultaneously for 3-5 seconds or until the blue FRONT light illuminates to indicate the system is activated.
Page 4
Programming Remote to work with the EZ Flow Trap & Hatch System Power on the keypad controller on the trailer by holding Status the “HOPPER OPEN” and “HOPPER CLOSE” buttons on the keypad simultaneously for 3-5 seconds or until the KEYPAD blue light illuminates to indicate the system is activated.
Page 5
Programming Remote to work with the Remote Lift Axle System Locate the remote lift axle relay enclosure in the nose of the trailer. RELAY MODULE Open the enclosure and locate the remote programming Program button on the bottom side of the relay module. Button Open the remote flip lid and observe the buttons illuminate indicating the remote is active.
Need help?
Do you have a question about the Thunder 7000 and is the answer not in the manual?
Questions and answers