Subscribe to Our Youtube Channel
Summary of Contents for Stanley PJMM-2465C
- Page 2 The Wall the Projector will be mounted on is either concrete or dry wall with wood studs.
- Page 3 M (x10） M5x6 (x2) M8 (x5) M4x25 (x4) M5x25 (x4) M6x25 (x4) Washer D (x4) E (x4) Wall Screw Wall Anchor M8x50 (x5) M5x12 (x4) Q (x4) G (x4) H (x4) I (x4) J (x4) F (x4) Washer For attaching Projector to Mount Assembly the PJ Mount itself Mounting plate Ceiling plate...
- Page 4 Insert the Connection Tube to the Ceiling Plate,and align the Ceiling Plate and the connection tube , insert 3 bolts(N) through the washers and tighten nut with a spanner. Insert the Extension Tube to the Connection Tube,align Extension Tube to the Connection Tube,insert 1 bolt(N) through the washers and tighten nut with a spanner.
- Page 5 Use ceiling plate as template making 4 marks with pencil to show where to drill the pilot holes. Remove the ceiling plate, drill the 4 pilot hole with a 3/8” drill bit ( hole depth 2”/ 50mm ). Insert the plastic anchors(E) into the 4 pilot holes .Tap gently with a hammer.
- Page 6 Use a stud finder to locate a ceiling joist.Then draw a horizontal line on the center of the stud. Use the ceiling mount as a template aligning it with the center of the stud. Make 4 pencil marks to show where to drill. Remove ceiling plate, drill the 4 pilot holes with a 3/16”...
- Page 7 Align the 4 Extension plates with the Wings of mounting plate. Insert the 4 screws(P) through the square washers(Q) and tighten.
- Page 8 Check what screws will fit in you projector (A,B,C). Align the mounting plate onto the top of the projector and install with the appropriate hardwares. Note :if your projector has a curved top you may need to use the longer screws with corresponding spacers.
-
Page 9: Mount Plate
Lift the projector with the mount plate and insert the short connection tube on the top of mounting plate into the extension tube. Align the Extension Tube to the short connection tube on the top of mounting plate, insert 1 bolts through the washers and tighten nut with a spanner.
Need help?
Do you have a question about the PJMM-2465C and is the answer not in the manual?
Questions and answers