Nienkamper METRONOME FLIP TOP Installation Manual

METRONOME FLIP TOP TABLE
INSTALLATION GUIDE
TOOLS REQUIRED:
4mm Hex Key
Philips Screwdriver / Bit
Drill
With the table top upside down on a protective surface, align base
through holes with threaded inserts in top. Be sure to position the
base so the actuator cable and release tab face center inserts.
Install Shoulder Bolts into center threaded inserts. Be sure to
position the actuator cable behind Shoulder Bolts with Tab facing
out.
Customer Support: 1.800.668.9318
Email: mail@nienkamper.com
Web: www.nienkamper.com
HARDWARE:
1/4"-20 x 9/16"
Joiner Bolt
Center inserts
THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
#8 x 5/8"
Pan Head
Wood Screw
Actuator
Cable Cover
Fix base assembly in place using 1/4"-20 x 9/16" Joiner Bolts.
Align thru holes in Actuator Cover with pilot holes in top. Position
cover with Actuator Tab sticking out through notch and fi x with #8
x 5/8" pan head wood screw.
PAGE 1 OF 2
SUGGESTED MINIMUM CREW:
APPROXIMATE INSTALL TIME: 30 min.
Shoulder
Bolt
Modesty Stop
Bracket
2
Wire
Management
Clip
Ganging Clip &
Thumbscrew