Kangaroo Z Series Quick Start Manual

2021 model spectrum spread

Hide thumbs

Table Of Contents

2021 MODEL

Quick Start Guide

Chassis

Steering

Structure

Your Kangaroo Z-series will arrive in five separate pieces. They are the

handle, chassis, rear push-button release wheels and steering structure.

Step 1: Attach Rear Wheels

• Remove protective covers from main axle.

• On outside of rear wheels, locate and push wheel release button.

• Place wheel on axle, aligning drive pins on axle with four holes in

wheel panel.

CaddieCommand

Remote Guidance

Upper Bag

Support

Push-Button Release

Wheels

Table of Contents

Need help?

Do you have a question about the Z Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Kangaroo Z Series

Page 1 Chassis Push-Button Release Wheels Steering Structure Your Kangaroo Z-series will arrive in five separate pieces. They are the handle, chassis, rear push-button release wheels and steering structure. Step 1: Attach Rear Wheels • Remove protective covers from main axle. • On outside of rear wheels, locate and push wheel release button.
Page 2 Push release button Inserting wheel on axle Free Wheeling Mode Free-wheeling allows the rear wheels to turn freely without engaging drivetrain. If you need to pull or push your caddie without power, always put it in Free-Wheeling mode first. This prevents strain on gears. Push release button on outside of wheel. Slide wheel outward slightly on the axle. Release button to allow it to lock in the proper groove.
Page 3 Step 3: Attach Handle Assembly • Open draw latch on top of chassis. • Insert handle assembly into hole, secure with draw latch. • Attach wire plug to receptacle on backside of Z-box. • Remove three plastic tie-wrap bands from handle. Insert handle assembly into chassis. Be sure to twist collar when attaching and detaching handle wire.
Page 4 Manual Operation Before putting your bag on and hitting the links, practice using manual and remote operation. • Place battery in tray and plug in specially designed T-bar. • Set function switch to OFF. • Set speed control all the way down, set function switch to MANUAL. Slowly adjust thumb knob up to increase speed. Connect T-bar to battery. Make sure T-bar is solidly connected matching positive to positive and negative to negative. 3-way toggle Function Switch Speed Control: thumb knob...
Page 5 Remote Control Toggle function switch to REMOTE. Adjust speed control to desired setting. SET a normal walking pace to start with. • GO: Caddie will travel at speed selected on speed control. • FAST: Light blinks green to confirm command. After a 2 second pause caddie travels at maximum speed. Press GO to return to your pace selected on speed control knob. • LEFT: Front wheel will turn left. Release button to automatically re-center.
Page 6 John at our factory in Columbus, North Carolina is glad to help you, Mon-Fri 8-4 Eastern Time. John Raines factory shipping address: Technical Service Kangaroo Products Co. 828-436-2101 ext. 2400 111 Kangaroo Drive Columbus, NC 28722 johnraines@KangarooGolf.com www.KangarooGolf.com For instant information: www.kangaroogolf.com/faq/z-series-faqs.html...