Page 1
Remote Control Cooler Applies to Models: ROVER, TRUCK Styles and colors may vary Designed, Molded and Assembled in the USA Owner’s Manual This manual contains assembly, use and maintenance instructions. The remote controlled cooler must be assembled by an adult who has read and understands the instructions in this manual.
Thank You For Your Purchase If you have any questions or comments, please contact us at: C3 Custom Cooler Creations 100 South CP Avenue Lake Mills, WI 53551 1-844-723-4909 c3@seljan.com www.c3customcoolers.com Important! Do not return the product to the store. Please contact customer service at 1-844-723-4909 for assistance and replacement parts.
Safety WARNING! General Warnings • Contains small parts, for adult assembly only. Keep small children away when assembling. Remove and dispose of all packaging material before assembly. Be sure to remove all packaging materials and parts from underneath the RC cooler body. •...
WARNING! Battery Warnings • Use of a battery or charger other than the 12V rechargeable battery and charger supplied with the C3 cooler may cause a fire or explosion. Only use the supplied 12V rechargeable battery and charger with the C3 cooler. •...
WARNING! User Requirements and Warnings • Age Range: 16 years and older • Maximum Load Weight: 60 lbs. • Do not ride on, sit or stand on remote controlled cooler • Only operate remote controlled cooler under adult supervision • Always operate remote controlled cooler within your line of sight •...
Parts Important! Check that you have all parts before assembly. (1) Cooler Body • Includes: • (1) 12 volt, 10A battery • (2) working headlights • (2) speakers (1) Front axle assembly (1) Front steering rod (1) Rear axle rod (6) Washers (1) Lock nut (1) Bolt...
Page 7
Parts Important! Check that you have all parts before assembly. (6) Cotter pins (4) Wheels (4) Hubcaps (1) Battery Charger (1) Remote Control (2) AAA Batteries To order replacement parts, refer to our website: www.c3customcoolers.com...
Assembly Attaching Wheels Tools required: Phillips head screwdriver, wrench or needle nose pliers Assembly time: 10 minutes remove rubber Step 1 band Place cooler body upside down on a non-abrasive, clean surface. Remove rubber band from rear gear box assembly. Holding gear boxes firmly in place, slide rear axle through gear boxes.
Page 9
Assembly Step 5 Insert steering rod into gear box. Using a Phillips head screwdriver and wrench, secure steering rod in place with bolt and lock nut. Step 6 Place a washer on left front axle, then wheel, then another washer. Make sure the flat side of wheel faces out as shown.
Charging the battery Locate battery charger Plug round end of charger into charging port on back of cooler Plug pronged end of charger into a standard 120V wall outlet • Do not use an extension cord Charge cooler for 12 hours to ensure a full charge After charging is complete, unplug charger from wall and cooler Re-Charging Interval and Time •...
Cooler Operating Parts Remote Control: Use to steer cooler right, left, forward and reverse Power Switch: Flip switch to turn power on and off Headlight Switch: Flip switch to turn headlights on and off Speaker Switch: Flip switch to turn speakers on and off MP3 Player Port: Plug in MP3 player here using MP3 cable included Battery Charging: •...
Operating Remote Control Pairing the Remote to the Cooler • Ensure (2) AAA batteries are installed in the remote • Ensure cooler power is switched OFF • Press and HOLD Pairing Button. The green indicator light above button will blink rapidly •...
Maintenance • Check the tightness of wheels • Ensure the battery is properly charged before use • Occasionally use lightweight oil to lubricate moving parts such as wheels and steering linkage. Do not oil plastic parts. • Store the cooler indoors or cover it with a tarp to protect it from the wet weather.
Troubleshooting Problem Possible Cause Remedy RC cooler does not Remote is not paired Pair remote using instructions on page work properly out of 12 of this manual. Electronics disconnected Remove large back access panel and ensure all wire connectors are securely attached.
Page 15
Troubleshooting Problem Possible Cause Remedy 12V Battery will not Battery connector or Verify battery connectors are firmly recharge adapter connector is loose plugged into each other. If wires are loose around motor call Consumer Relations at 1-844-723-4909 for service. Charger not plugged in Ensure battery charger is plugged into a working wall outlet.
Warranty Policy 90 Day Limited Warranty Seljan Company warrants that this product will be free from defect due to material and workmanship under normal use for a period of 90 days from the date of purchase. Please retain receipt for proof of purchase. Proof of purchase is required for any warranty claim.
Need help?
Do you have a question about the ROVER and is the answer not in the manual?
Questions and answers