Mounting And Installation; Preparation - Siemens POS8.4420/109 Basic Documentation

4 Mounting and installation

4.1 Preparation

Check package contents
Check operating
conditions
Check locations
A6V11471220_en--_e
Comply with the following notes as well as the Mounting instructions
(A6V10733764) to mount the room operation unit.
Check the package contents for visible signs of transport damage and for
completeness.
Do not install parts damaged during shipment. Contact your Siemens
representative in the event of damaged parts.
Note the information in the data sheet of these operating instructions before
installing the device:
● Climatic ambient conditions
● Protection classes
● The devices are suitable for wall mounting and panel mounting.
● Recommended height: 1.50 m above the floor.
● Do not mount the devices in recesses, shelves, behind curtains or doors, or
above or near heat sources.
● Avoid direct solar radiation and drafts.
● Seal the conduit box or the installation tube if any, as air currents can affect
sensor readings.
● Adhere to allowed ambient conditions.
Mounting and installation
Preparation
4
11 | 70