STB 2400 User Instructions

Electronic timelocks

Advertisement

WARRANTY
Unless otherwise specified, STB microtechniques model 114
Timelock movements are warranted for two years to be free from manufacturing
defect.
Any movement which proves to be defective during this time period should be
returned to the place of purchase, freight paid, with a complete explanation of the
failure.
At the option of the manufacturer, the movement will be repaired or
replaced at no cost to the original purchaser.
Customer abuse, neglect or unauthorized modifications, service, repair, act of war,
acts of nature are not covered by this warranty. Consequential damages which may
arise through the use or misuse of these products shall not be borne by the
manufacturer or his agents.
Except as noted herein, there is no other warranty expressed or implied. The
manufacturer reserves the right to amend, alter, extend or deny warranty coverage
at his option without prior notice.
NOTES
STB microtechniques electronic Timelock movements are precision instruments
which are highly accurate and dependable when given minimal care. The following
are guidelines which will ensure years of trouble free service.
E
Model 114
and 134 electronic Timelock Movements are designed for use in
industry accepted (U.L. approved) Timelock cases which utilize the original Yale
screw mounting pattern. Installation in any container other than accepted Timelock
cases exposes these movements to potential damage, may cause a lock-out of the
secured container and voids the warranty.
Operating temperature ranges are 0° to +30° Celsius (+32° to +86° Fahrenheit).
Relative humidity should not exceed 85%.
Varta Button cells are the recommended replacement battery for STB electronic
Timelock movements. Duracell button cells may be substituted when Varta is not
readily available. In any case, only use UL approved batteries.
Except for replacing the power cell, there are no end-user serviceable components
E
in STB model 114
or 134 electronic Timelock movements.
sales@stbmicro.com
www.stbmicro.com
E
or 134 electronic
CH-2072 Saint-Blaise Switzerland
Tel: +41 32 756 10 30 Fax: +41 32 756 10 49
Electronic Timelocks
Models 2400 and 1600

Introduction

Movements setting

Door Locking

Notes and warranty

©
2006-07

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2400 and is the answer not in the manual?

Questions and answers

Summary of Contents for STB 2400

  • Page 1 Operating temperature ranges are 0° to +30° Celsius (+32° to +86° Fahrenheit). Relative humidity should not exceed 85%. Varta Button cells are the recommended replacement battery for STB electronic Timelock movements. Duracell button cells may be substituted when Varta is not readily available.
  • Page 2 The locking lever should be in the OPEN position at this time. The boltwork STB electronic Timelocks (1600 or 2400 series) are available either is not blocked as long as the locking lever is in the OPEN position and the...

This manual is also suitable for:

1600

Table of Contents