Advertisement
GRIT Junior: Anti-Tip Bars Installation Guide
Tools Required:
Large Phillips (cross-head) screwdriver, 13mm (or adjustable) wrench, 5mm hex key (came with your
Freedom Chair)
These Anti-Tip Bars help you ride securely by making it harder to tip the Freedom Chair backward. They
come pre-set in a safe riding position. You may adjust their length.
The Anti-Tip Bars cannot prevent every possible accident:
• You are responsible for your safety. Ride within your limits. If you feel unsafe, stop.
• Ride with a spotter behind your chair while getting used to the Freedom Chair and Anti-Tip Bars,
especially on ramps and uneven terrain.
• Do not build up backward momentum. Rolling backward on a ramp, even with Anti-Tip Bars
installed, is dangerous and could cause a fall.
1
Remove the nut and
washer from one of
the two rear seat
bolts. Keep the bolt in!
Just take off the nut
and washer.
2
Slide the Anti-Tip Bar
over the exposed bolt
thread. Tighten the
nut back onto the bolt.
Do not include the
washer!
Have a question? Call 617-356-8106 or email support@gogrit.us.
Advertisement
Table of Contents
Related Manuals for GRIT Junior
Summary of Contents for GRIT Junior
- Page 1 GRIT Junior: Anti-Tip Bars Installation Guide Have a question? Call 617-356-8106 or email support@gogrit.us. Tools Required: Large Phillips (cross-head) screwdriver, 13mm (or adjustable) wrench, 5mm hex key (came with your Freedom Chair) These Anti-Tip Bars help you ride securely by making it harder to tip the Freedom Chair backward. They come pre-set in a safe riding position.
- Page 2 Anti-Tip Bar. The Anti-Tip Bars are shipped at GRIT’s recommended length. The length can be adjusted to make the bars more secure or more permissive. To adjust the bar length: • Use the 5mm hex key to loosen the clamps.
Need help?
Do you have a question about the Junior and is the answer not in the manual?
Questions and answers