Operation - AEG ZT-ST Instructions Manual

| DEUTSCH
Garantieleistung
Dieses AEG Werkzeug ist bei der Fertigung
mehrfach geprüft worden. Wir gewährlei-
sten Material und Ausführung. Versagt das
Gerät trotz sachgemäBer Behandlung infolge
eines Fertigungs- oder Materialfehlers inner-
halb der Garantiezeit von 6 Monaten, wird es
kostenlos instand gesetzt. Die Garantie gilt ab
Lieferdatum und nur bei Vorlage der Kauf-
unterlagen.
| ENGLISH
General view
Fig. I
O Saw table
© Jigsaw insert
® Countersunk screw for securing jigsaw
® Screw clamp
Technical data
Size of table: 200 x 200 mm
Angular cuts up to: 45°
Weight: approx. 0.6 kg
Scope of delivery
Saw table, .2 jigsaw inserts, 3 countersunk
screws, 1 screw clamp.
Accessories
Fretsaw equipment LSA for fretsaw work.
Safety hints
1) Before carrying out any work on the jigsaw,
always remove the plug from the socket.
2) When sawing, always insure that the
workpiece is flat on the saw table and is not
pulled upwards by the saw blade.
3) Please also observe the safety hints in the
operating instructions for your motor jigsaw.
Operation
With the supplementary table ZT-ST all AEG
motor jigsaws can be converted to stationary
jigsaws.
Mounting as stationary
jigsaws
Fig. 2
First secure the saw table (1) to a workbench
or table by means of the screw clamp (4).
Place the jigsaw against the saw table from
below, so that the securing screws in the base-
plate of the jigsaw coincide with the holes in
the saw table. As the table can be used with
all motor jigsaws, two different sets of holes
are present on the plate. When the jigsaw is
applied you will easily recognize which holes
are intended for your saw.
Secure the jigsaw to the saw table by means of
the three countersunk screws (3).
In order to insure high stability of the table, the
table was designed in such a way as to locate
the jigsaw as near as possible to the work-
bench or table to which the saw table is
attached. For this reason the saw must be
turned round in the case of angular cutting,
depending on the desired cut.
Straight cuts
Fig. 3
For straight cuts the inserted jigsaw is pushed
forward until the saw blade is introduced into
the small slit in the plastic insert.