Page 1
INSTRUCTIONS FOR USE P R O F E S S I O N A L H O R S E C L I P P E R L I V E R Y M A N . C O . U K...
Page 2
INSTRUCTION MANUAL FOR BLACK BEAUTY CLIPPER To ensure you achieve the best possible results from your clipper, please read the following instructions carefully before use. The latest generation brushless motor should give many years of service providing guidance offered in this manual is adhered to.
Always use sharp clipping blades and have a spare set with you before commencing clipping. • Use the oil provided or Liveryman clipping oil. Never use diesel oil. • Lack of lubrication can result in unsatisfactory clipping results and overheating of the clipper.
PUTTING INTO SERVICE MAINS OPERATION 1. Switch mains wall socket off. The socket must be in good working order and electrically. 2. Plug charger adapter into mains supply wall socket. 3. Switch clipper off. 4. Push together connectors from charger adapter and clipper leads. 5.
• A set of blades is a top cutter and bottom comb. • Place the smaller cutter blade onto the clipper head with ground face uppermost. • Apply Liveryman oil to the ground (shiny) surfaces and clipper crankhead, inside the cutter bracket.
BATTERY PACK CHARGING • To charge the battery pack plug the mains charging cable cable into the socket marked DV IN 9V-12V/3A. • The blue battery capacity LED indicator lights will increase as the battery charges and • Only use the adapter supplied decrease as battery discharges for charging the battery pack.
Page 8
8 seconds. IMPORTANT: Black Beauty AND Bruno clippers cannot be operated at the same time. Always replace the rubber caps when the socket/s are not in use.
TROUBLESHOOTING FAILURE CAUSE ACTION Blades do not Hair/dirt between blades Remove blades. Clean, oil and clip reassemble Blunt Blades Have blades re-sharpened Lack of Oil Regularly oil blades every 5-10 minutes Incorrect tension Re-tension blades correctly Blades Lack of Oil Regularly oil blades every 5-10 minutes overheating Too much tension...
TROUBLESHOOTING (BATTERY PACK) FAILURE CAUSE ACTION No Power Check start button has been depressed Battery pack low Charge battery pack No power after Discharge battery fully by running charging clipper. Until it stops. Do not attach blades during this operation. Allow 15 minutes to cool battery pack.
Whilst every care has been taken in the compiling of information within our instructions, Liveryman (Agrihealth Ltd) accepts no responsibility for any errors or omissions in technical data or other information as stated. BLACK BEAUTY MAINS MODEL...
Page 12
L I V E R Y M A N . C O . U K Find us on @LiverymanClippers @liveryman_ L I V E R Y M A N . C O . U K...