Advertisement
Watts economizer
For more economical use, the Min. or Med. Watt switches
may be used individually, after unit has reached the opera-
ting temperature.
With pilot lights ON, the heater is ON.
1. Location
Place heater on the floor beneath the coldest window in the
room, or any other location. Your heater will reduce the effect
of cold drafts. The heater should not be placed immediately
below a power outlet.
Do not use this radiator in rooms with a floor area of less than
43 square feet (4 sq. m.).
2. Connection
The radiator should be connected to a properly polarized A/C
120 V household outlet in perfect working conditions.
Keep loose clothing or bedding, furniture and flammable ma-
terial away from the heater's wall outlet.
3. Turning on two-switch models
Turn the thermostat clockwise to its maximum position. Push
down both switches. The switch lights stay on independently
of the thermostat cycling. When room reaches the desired
temperature, turn the thermostat knob counter-clockwise
very slowly and carefully until you hear a click. This should set
your heater to maintain the desired temperature by cycling
on and off as required.
Please note: The heater normally requires about 15
minutes to reach the desired temperature.
4. Use of thermostat
The thermostat operates according to room air temperature,
rather than radiator temperature.
Turning it counter-clockwise to smaller numbers would de-
crease the temperature; clockwise to greater numbers would
increase the temperature.
Antifreeze function
Turn the thermostat dial to the
switches on.
The appliance will maintain a minimum room temperature
of approximately 42°F (5°C), thus preventing freezing while
conserving energy.
Please note: To completely shut the heater off, MIN/
MED switches must be set in the "0" position.
Your product is equipped with a polarized alternating
current line plug (a plug having one blade wider than
the other). There is only one way it can be plugged into
a power supply. This is a safety feature. If you are una-
ble to insert the plug fully into the outlet, try again
by turning it the other way. If it would still not go in,
it is probably due to an obsolete outlet which should
be replaced. Do not temper with the plug or outlet to
defeat the purpose of this safety mechanism.
A safety device
A safety device switches the heater off in the event of overhe-
ating. To restart the heater, call the nearest Service center.
5. MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow
the radiator to cool. Wipe radiator with a soft damp cloth; do
not use detergents and abrasives. Should the radiator not be
in use over a certain length of time, roll the cable around the
holder and store it in a dry place (see fig. on front page).
This appliance has been built to last for many years of trou-
ble-free service. In case of malfunction or doubt, do not try to
repair the heater by yourself: this might increase the risk of
fire and electric shock. Call nearest Service Center Visit www.
delonghi.com for a completelist of Service Centers (U.S. Only).
6
position and push the
Advertisement
