Eco-Flo ESE50WB1830 Owner's Manual

Eco-Flo ESE50WB1830 Owner's Manual

Pre-plumbed sewage basin system

Advertisement

Owner's Manual
Pre-Plumbed
Sewage Basin System
ESE50WB1830
TABLE OF CONTENTS
Features. . . . . . . . . . . . . . . . . . . . . . . 2-3
Installation . . . . . . . . . . . . . . . . . . . . . .4-5
Safety Information. . . . . . . . . . . . . . . . 6-7
Warranty . . . . . . . . . . . . . . . . . . . . . . . . .8
RSE50WB1830

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ESE50WB1830 and is the answer not in the manual?

Questions and answers

Summary of Contents for Eco-Flo ESE50WB1830

  • Page 1 Owner’s Manual Pre-Plumbed Sewage Basin System ESE50WB1830 RSE50WB1830 TABLE OF CONTENTS Features..... . . 2-3 Installation ..... .4-5 Safety Information.
  • Page 2: Features

    Float Switch Solids Handling Warranty Model 0’ 5’ 10’ 15’ shut off Off RSE50WB1830 5700 5980 4020 2520 18’ 15.5” 7.5” 2” ESE50WB1830 7500 6960 5880 4500 24’ 15.5” 7.5” 2” For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561...
  • Page 3 • Strong, durable ABS body • Flow arrows clearly marked • Fits 2” black, galvanized and PVC Schedule 40 pipe Basin Inlet Hub • Water and vapor-tight seal • Fits 4” DWV SCH.40/80 • Built-in “O” rings • Stainless steel clamp For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561...
  • Page 4: Installation

    • Connect the inlet piping (1) as required by code using the 4 in. snap-in inlet hub (D). Hand-Tighten the hose clamp. • Carefully backfill with naturally rounded gravel or stone, larger than 3/8 in. and smaller than 3/4 in. diameter,around the periphery of the basin (A). For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561...
  • Page 5 6. Connecting the power and verifying proper operation • Make sure that the cord grommet is properly inserted into the lid. This assures a water and gas tight seal. • Check the pump by filling the basin with water and observe the pump’s operation through one complete cycle. For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561...
  • Page 6: Safety Information

    ATTEMPTING TO USE A DAMAGED PUMP can result or in water. lf basement floor is wet, do not walk on wet in property damage, serious personal injury, and/or area until all power is turned off. If shut-off box is in death. basement, call the electric company to shut off service to the house, or call your local fire department for instructions. WARNING: Ensure that the electrical circuit to the Remove pump and repair or replace. Failure to follow pump is protected by a 15 Amp fuse or circuit this warning can result in fatal electrical shock. breaker. CAUTION: Do not lift the pump by the power cord. For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561...
  • Page 7 WARNING: DO NOT remove the grounding prong from the plug or modify the plug. To protect against electrical shock, the power cord is a three-wire conductor and includes a 3-prong grounded plug. Plug the pump into a 3-wire, grounded, grounding type receptacle. Connect the pump according to electrical codes that apply. For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561...
  • Page 8: Warranty

    WARRANTY Retain Original Purchase Receipt for Warranty Eligibility Limited Warranty Manufacturer warrants to the original consumer purchaser (“Purchaser” or “You”) that its products are free from defects in material and workmanship for a period of two (2) years (ESE50WB1830) and one (1) year (RSE50WB1830) from the date of the original consumer purchase. If, within one/two years from the original consumer purchase, any such product shall prove to be defective, it shall be repaired or replaced at manufacturer’s option, subject to the terms and conditions set forth herein. Note that this limited warranty applies to manufacturing defects only and not to ordinary wear and tear. All mechanical devices need periodic parts and service to perform well. This limited warranty does not cover repair when normal use has exhausted the life of a part or the equipment. The original purchase receipt and product warranty information label are required to determine warranty eligibility. Eligibility is based on purchase date or original product – not the date of replacement under warranty. The warranty is limited to repair or replacement of original purchased product only, not replacement product (i.e. one warranty replacement allowed per purchase). Purchaser pays all removal, installation, labor, shipping, and incidental charges. Claims made under this warranty shall be made by returning the product to the retail outlet where it was purchased or to the factory immediately after the discovery of any alleged defect. Manufacturer will subsequently take corrective action as promptly as reasonably possible. No requests for service will be accepted if received more than 30 days after the warranty expires. Warranty is not transferable and does not apply to products used in commercial/rental applications. General Terms and Conditions; Limitations of Remedies You must pay all labor and shipping charges necessary to replace product covered by this warranty. This warranty does not apply to the following: (1) acts of God; (2) products which, in manufacturer’s sole judgment, have been subject to negligence, abuse, accident, misapplication, tampering, or alteration; (3) failures due to improper installation, operation, maintenance or storage; (4) atypical or unapproved application, use or service; (5) failures caused by corrosion, rust or other foreign materials in the system, or operation at pressures in excess of recommended maximums. This warranty sets forth manufacturer’s sole obligation and purchaser’s exclusive remedy for defective products. MANUFACTURER SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES WHATSOEVER. THE FOREGOING LIMITED WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS...

This manual is also suitable for:

Rse50wb1830

Table of Contents