Advertisement
WARNING!
NEVER USE A POT OR PAN OVER 26CM DIAMETER.
USE OUTDOORS ONLY.
IMPORTANT
Read these instructions for use carefully. Familiarise yourself with the appliance before connecting
it to it's gas container. Keep these instructions for future reference.
This appliance shall only be used with a Butane gas cartridge certified to EN 417 or equivalent.
IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPES OF GAS CONTAINERS.
* REMOVE ANY TRANSIT PROTECTION MATERIAL.
PARTS LIST
Burner Head
Pan Support
Drip Tray
Cartridge Lever
Ignition Knob
TWIN OVER-PRESSURE SAFETY DEVICES
When used in extreme conditions or if the Instructions are not adhered to, the internal pressure of the gas cartridge may rise
to a hazardous pressure.
The 1st over-pressure safety device will activate and eject the gas cartridge. To reset after activation remove the gas cartridge
and hold it vertically with the nozzle facing upwards away from your face. Check the cartridge temperature and if it is warm
or hot place it in an area to cool down to ambient temperature. Once cool carefully depress the nozzle momentarily to release
the high pressure gas, ensuring that no heat source or naked flame is in the vicinity.
If for any reason the 1st stage ejection does not activate the 2nd over-pressure safety device will shut off the gas supply to
the burner, to reset after activation remove the gas cartridge as described above and release the pressure as indicated. On the
inner side of the regulator locate the red button and press it in one smooth action (Fig. 6).
It is strongly recommended and essential to consider what has caused the pressure within the cartridge to rise beyond the
safe operating limit and rethink how the appliance is being used. "Are the Instructions being followed?"
If you have any concerns email our Customer Service centre.
OPERATING INSTRUCTIONS
Inserting the Gas Cartridge
1.
Turn the Ignition Knob to 'OFF ' and set the Cartridge Lever to 'UNLOCK' (Fig. 1).
Note: If the Ignition Knob is not in the 'OFF' position the gas cartridge cannot be locked.
2.
Open the Cartridge Cover: Slide the gas cartridge, top end first and with its notch up, into the
compartment. Align cartridge collar notch with the red locator tab on the appliance (Fig. 2).
3.
Push the Cartridge Lever down to 'LOCK' in one firm motion (Fig. 3).
Lighting the Stove
1.
Push and turn the knob anti-clockwise past the 'ON' position until a click is heard (Fig. 4).
2.
If the burner fails to light, immediately turn the Ignition Knob to 'OFF' position and repeat Step 1.
To Adjust Heat
Flame can be controlled by turning the Ignition Knob between the 'ON' and 'OFF' position.
To Shut Off
1.
Turn the Ignition Knob to 'OFF' to shut off fuel supply (Fig. 5). Wait until the flame is fully
extinguished before performing the next step.
2.
Raise the Cartridge Lever to 'UNLOCK' and remove the gas cartridge from the compartment.
Cartridge Cover
Note: Do not leave the gas cartridge inside the unit when not in use or storing the product.
After Use
1.
Replace the cap on the gas cartridge after removing it from the unit. Store upright in a cool dry place.
2.
Make sure the burner is cool to touch before packing unit away.
3.
DO NOT store the cartridge near other flammables.
DO NOT store the cartridge near sources of heat or direct sunlight.
DO NOT store in the glove compartment or boot of your car.
DO NOT puncture or incinerate empty cartridges.
Check that the seals between the appliance and the gas container are in place and in good condition before connecting
the gas container.
•
Leak test the regulator and cannister connection before use with a soapy water solution.
•
DO NOT use this appliance if it has damaged or worn seals.
•
DO NOT use this appliance if it is leaking, damaged or does not operate properly.
•
The cartridge may be disconnected even if some gas remains.
•
Check the contents by shaking and listening for the liquid gas.
Gas containers shall only be changed in a well ventilated location, preferably outside, away from people and way from
sources of ignition; such as naked flames, pilot flames, electric heaters/equipment.
If there is a leak on your appliance (smell of gas) and you cannot stop the gas flow, remove the appliance to a well
ventilated location away form any ignition source. Only check for leaks outdoors using soapy water. DO NOT try to detect
leaks using a flame.
This appliance must only be serviced by an authorised person.
NOTE: The stove efficiency will be reduced in strong windy conditions. In this case use outdoors in wind protected areas.
WARNING!
THE OPENINGS AT THE BASE OF THE BURNER PROVIDE AIR FOR COMBUSTION, THEY SHOULD NEVER
BE OBSTRUCTED. IF THE FLAME BECOMES SIGNIFICANTLY ORANGE CHECK THESE OPENINGS FOR A
BLOCKAGE. IF THE APPLIANCE CANNOT BE ADJUSTED TO PERFORM CORRECTLY IT SHOULD NOT BE
USED UNTIL SERVICED OR REPAIRED.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Red Reset Button
Red Cartridge Guide
Advertisement
