Page 1
Assembly Instructions Viola/Violin Rack Step 1: On a protected flat surface and with the help of another person, align the threaded inserts of the (lower) rails to the (lower) brace • Using a 1/4”-20x1 3/4” joint connector bolt, insert the bolt going through the pre-drilled hole in the rail to the threaded insert of the brace.
Page 2
Step 2: With the help of another person, align the threaded inserts in the (lower) rail assembly with the pre-drilled holes in (right) side panel. • Using a 1/4”-20x1 3/4” joint connector bolt, insert bolt going through the hole in the side panel to the threaded insert. Use a 4mm Allen wrench or •...
Page 3
Assembly Instructions Viola/Violin Rack Step 3: Align the threaded inserts in the (lower) support rail with the pre-drilled holes in the (right) side panel. Using a 1/4”-20x1 3/4” joint connector bolt, insert the • bolt going through the pre-drilled hole to the threaded insert. Use a 4mm Allen wrench or 4mm hex bit and a screw gun to fasten the bolt into place.
Page 4
Assembly Instructions Viola/Violin Rack Step 4: Align the threaded insert in the (lower) neck holder with the pre-drilled hole in the (lower) support rail.. Using a 1/4”-20x1 3/4” joint connector bolt, insert • the bolt going through the pre-drilled hole to the threaded insert. Use a 4mm Allen wrench or 4mm hex bit and a screw gun to fasten the bolt into place.
Page 5
Assembly Instructions Viola/Violin Rack (SIDE VIEW) Step 6: • With the help of another person, place the rack on it’s back on a protected flat surface. • Attach the reinforcement bracket to the side panel by using a 1/4”-20x20mm joint connector bolt going through pre-drilled hole in the bracket and the side panel and making sure bolt is pushed as far as it can go.