Advertisement
Quick Links
Step 1:
On a protected flat surface and with the help of another person, align the threaded inserts of the (lower)
•
Using a 1/4"-20x1 3/4" joint connector bolt, insert the bolt going through the pre-drilled hole in the
•
wrench or 4mm hex bit and a screw gun to fasten the bolt into place. Repeat for the remaining (3) bolts.
After the first
rail
is attached to the brace, repeat for the remaining
•
Repeat this step with (upper)
•
Rails w/ Armor
Edge (shown in
pink)
Tools Required
•
4mm Allen
Wrench OR
•
4mm hex bit
•
Phillips screw
driver
•
Screw gun
•
Square screw
driver
NOTE:
Colored images are for illustrative purposes only.
Specifications are subject to change. Product
wibenchmfg.com
images are for illustrative purposes only and may
rails
and (upper) braces.
(Upper)
(Lower)
differ from the actual product.
Assembly Instructions
rail
rail
on the other side of the
brace.
Viola/Violin Rack
rails
to the (lower)
brace
.
to the threaded insert of the brace. Use a 4mm Allen
Braces (shown in
green)
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
V072121 Version subject to change
1
Advertisement
Summary of Contents for WB Mfg Viola
- Page 1 Assembly Instructions Viola/Violin Rack Step 1: On a protected flat surface and with the help of another person, align the threaded inserts of the (lower) rails to the (lower) brace • Using a 1/4”-20x1 3/4” joint connector bolt, insert the bolt going through the pre-drilled hole in the rail to the threaded insert of the brace.
- Page 2 Step 2: With the help of another person, align the threaded inserts in the (lower) rail assembly with the pre-drilled holes in (right) side panel. • Using a 1/4”-20x1 3/4” joint connector bolt, insert bolt going through the hole in the side panel to the threaded insert. Use a 4mm Allen wrench or •...
- Page 3 Assembly Instructions Viola/Violin Rack Step 3: Align the threaded inserts in the (lower) support rail with the pre-drilled holes in the (right) side panel. Using a 1/4”-20x1 3/4” joint connector bolt, insert the • bolt going through the pre-drilled hole to the threaded insert. Use a 4mm Allen wrench or 4mm hex bit and a screw gun to fasten the bolt into place.
- Page 4 Assembly Instructions Viola/Violin Rack Step 4: Align the threaded insert in the (lower) neck holder with the pre-drilled hole in the (lower) support rail.. Using a 1/4”-20x1 3/4” joint connector bolt, insert • the bolt going through the pre-drilled hole to the threaded insert. Use a 4mm Allen wrench or 4mm hex bit and a screw gun to fasten the bolt into place.
- Page 5 Assembly Instructions Viola/Violin Rack (SIDE VIEW) Step 6: • With the help of another person, place the rack on it’s back on a protected flat surface. • Attach the reinforcement bracket to the side panel by using a 1/4”-20x20mm joint connector bolt going through pre-drilled hole in the bracket and the side panel and making sure bolt is pushed as far as it can go.
- Page 6 Assembly Instructions Viola/Violin Rack Part Identifier Key Description Qty. Part # Qty. Description 1/4”-20x1 3/4” joint connector 0406517 Varies bolt 0400861 14g reinforcement bracket Side panel 1/4”-20x17mm joint connector 0404229 1/4”-20x20mm joint Rail w/ Armor 0404228 connector bolt w/ loctite...