Advertisement
STEP 1: POPULATE ALL SMALL COMPONENTS ON THE BOARD SUCH AS RESISTOS, RIGHT ANGLE JUMPERS,
DIODES AND SMALL CAPACITORS. THROUGHOUT YOUR BUILD, ALWAYS INSTALL THE SMALLER PARTS FIRST,
WORKING YOUR WAY UP TO THE LARGER COMPONENTS
PAY CLOSE ATTENTION
TO THE GRAY BAND ON
EACH DIODE AS THEY ARE
DIRECTIONAL
FLAT SPOT OR THE
SHORT LEAD ON RED LED
(INDICATES NEGATIVE
SIDE OF LED) MUST FACE
TUBE SOCKET AS SHOWN
NOTCH ON THE RGB LED
(ORIENTATION MARKING)
MUST FACE THE WHITE
MARKING ON THE PCB AS
SHOWN
PAY CLOSE ATTENTION TO
THE BLACK BAND ON EACH
OF THESE FOUR DIODES AS
THEY ARE DIRECTIONAL
FLAT SPOT OR THE
SHORT LEAD ON RED LED
(INDICATES NEGATIVE
SIDE OF LED) MUST FACE
EXACTLY AS SHOWN
Advertisement
