Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for ADENDORFF MAC AFRIC DCSM02-100
-
Page 2: Electrical Safety
GENERAL POWER TOOL SAFETY WARNINGS If operating a power in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. (For All Power Tools) NOTE: The term “residual current device (RCD)” may be replaced by the term “ground fault circuit Failure to follow all WARNING! Read and understand all instructions. -
Page 3: Specifications
Such preventive safety measures reduce the risk of starting the power tool No-load Speed 8500 r/min Spindle Thread accidentally. Net Weight 1.4 Kg 1.4 Kg 1.4 Kg 20. Store idle power tools out of the reach of children and do not allow persons unfamiliar Total Weight (Battery Included) 2.4 Kg with the power tool or these instructions to operate the power tool. - Page 4 for damage or install an undamaged accessory. After inspecting and installing an The grinding surface of the centre depressed wheels must be mounted below the plane of accessory, position yourself and bystanders away from the plane of the rotating the guard lip. An improperly mounted wheel that projects through the plane of the guard lip cannot be adequately protected.
-
Page 5: Additional Safety Rules
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY AND Never place your hand near the rotating accessory. Accessory may kickback over your CHARGER hand. Do not position your body in the area where power tool will move if kickback occurs. Always set the reversing switch lever in the central position (lock the switch) and remove Kickback will propel the tool in direction opposite to the wheel’s movement at the the battery cartridge before tool change, inspection, maintenance, transportation, storage point of snagging. -
Page 6: Instructions For Operation
inspection. Continuous using of a worn out battery may result in a risk of overheating, INSTRUCTIONS FOR OPERATION possible burns and even an explosion. Do not expose battery cartridge to rain, snow or wet conditions. CAUTION: Store battery cartridge properly: Before any work on the machine itself (e.g. - Page 7 Mounting the Auxiliary Handle Installing or Removing the Battery CAUTION: Screw the auxiliary handle on the right or left of Use only specified type battery. Other types/brands of batteries may burst cause personal the tool head. (Fig. 4) injury and property damage. Spindle Lock ...
- Page 8 In general, keep the edge of the wheel or disc at an angle of about 15°-30° to the workpiece Model SCHARG-001 (FFCL18-04) surface. Input Voltage (AC) 220-240V During the break-in period with a new wheel, do not work the grinder in the B direction, or it Charging Current 3.0 A will cut into the workpiece.
-
Page 9: Inspecting The Mounting Screws
Continuous Use Insert the battery pack fully into the battery charger and the charger starts charging. If the tool is operated continuously until the battery cartridge has discharged, allow the tool The battery charger can detect some sort of failure caused by the battery and indicates by the to rest for 15minutes before proceeding with a fresh battery. - Page 10 EXPLAINATION OF GENERAL VIEW Outer Flange Baffle Plate Inner Flange Washer Wheel Guard Assembly Armature Drive Spindle Ball Bearing Pan Head Screw (with Spring Washer) Stator Assembly Dust Cap Stator Plate Bearing Box Pan Head Tapping Screw O Ring PCB Assembly Dust-proof Washer 32-1 PCB Aluminum Case...
Need help?
Do you have a question about the MAC AFRIC DCSM02-100 and is the answer not in the manual?
Questions and answers