Electrolux EW7W3R68SI Instruction Manual page 32

32 www.electrolux.com
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
10.6 Starting a programme
Touch the Старт/Пауза
start the programme. It is not possible to
start the programme when the indicator
of the button is off and doesn't flash (e.g.
the door is open).
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.7 Starting a programme with
the delay start
1. Touch the Отсрочка старта button
repeatedly until the display shows the
desired delay time. The related
indicator comes on.
2. Touch the Старт/Пауза
The appliance door locks and starts
the countdown of the delay start. The
display shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Старт/Пауза
pause the appliance. The related
indicator flashes.
2. Touch the Отсрочка старта button
repeatedly until the display shows .
3. Touch the Старт/Пауза
again to start the programme
immediately.
.
button to
button.
button to
button
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Старт/Пауза
pause the appliance. The related
indicator flashes.
2. Touch the Отсрочка старта button
repeatedly until the display shows the
desired delay time.
3. Touch the Старт/Пауза
again to start the new countdown.
10.8 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Старт/Пауза
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. During this phase
the Менеджер времени bars
placed below the time digits play a
simple animation, the drum rotates
shortly.
2. The programme duration will be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Старт/Пауза
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
button to
button
is
button to start