Bose CVT-5 Owner's Manual page 10

2. Connect the ground or negative lead to the
terminal labeled GND. Do not use the terminal
marked N/C, which has no function.
3. For parallel connections in a chain, connect the
next array's cable to the same terminals used
above.
Note: Bose
of the speaker cables. To make parallel connections efficiently, you
can attach the ends of the incoming and outgoing cables to a
single pair of spade lugs, which then attach to the selected
terminals.
If you do not use spade lugs, make sure that the incoming and
outgoing cables are of the same diameter. That will ensure an equal
force on them from the terminal strip flanges.
10
® recommends using solder-type spade lugs on the ends