Page 2
A commercial kitchen hood ventilation system can have many different power sources such as electric, gas and mechanical involving the hood system and other systems. Make sure to have the necessary qualifications before proceeding to installations, repairs or www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668...
Material clearance following the reception of material. If claims are done Make sure to respect the clearance standards from after this delay, Cadexair reserves the right to refuse combustible and semi-combustible material. the claim. exhaust kitchen hood must be installed 3 inches...
Lift the kitchen exhaust hood and fix the hood with the contamination. threaded rods. All of the kitchen exhaust hood mounting brackets must be held by a threaded rod. Adjust the height of the hood via the threaded rods www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...
Filters housing, exhaust collar and It is possible to install a hood skirting provided by cooking surface are sprayed with a chemical product. Cadexair or not above the hood. The installation Energy sources like gas and electricity are interrupted...
(SQ.M) to get an air flow in cubic meter per functioning of the exhaust hood. hour. To convert a cubic meter per hour air flow into Cadexair recommends the following method with liters per seconds, multiply the value by 0.278. measurements read with a propeller anemometer with a 2.75 inch wheel (70 mm).
Geo-Vary grease extractor. If modifications are to be made to the adjustment of the Geo-Vary filters according to new balancing requirements, contact Cadexair to receive new labels according the required adjustment. Maintenance Stainless Steel Stainless steel is very resistant to corrosion but it is not foolproof.
Remove the guillotine require annual inspections including from the extractor by removing the wing nut replacement of components intended in the standard. located inside the extractor, in the back. www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...
Most of the components are hard to find during the week-end; having them on hand facilitate maintenance. www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...
- If the inverter has power, cut the power and put it back on; some overload faults from the electrical network requires a reboot - Contact a qualified technician www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...
Page 13
- If the system is equipped with a rearming relay or Cadexair control panel, press on the reset button to power the cooking equipment back on Exhaust hood - If the system is equipped with a Cadexair control lights not panel, press on the reset button inside the control working...
Page 14
Doc150313-01 Installation and maintenance manual water valves and change them if necessary then contact Cadexair www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...
Installation and maintenance manual ANNEX 2 : Assembly diagram of an exhaust hood with mecanical joints (CA-W series) NOTE: Verify carefully the installation direction of the exhaust hood according to plans www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...
Put the guillotine and extractor upside down in a dishwasher or simply wipe the inside surfaces with detergent and hot water. • Put back the guillotine in the extractor according to hit initial setting and screw back the wing nut. www.cadexair.com 1010, Boulevard Lionel Boulet 1-800-461-0668 Varennes, Québec, Canada J3X 1P7...