Related Manuals for Raptor R00192
Summary of Contents for Raptor R00192
- Page 1 MINI GAS LEAK DETECTOR USER MANUAL R00192 R00190 Before using the instrument, please read this manual carefully and save for future reference.
- Page 2 Safety information Safety Information. In order to use the gas leak detector correctly, please read the instructions carefully before use, noting any safety information. It is recommended that you keep this instruction manual safe for future reference. Warning. A Warning identifies conditions and actions that pose hazards to the user.
- Page 3 Safety information 5. Replace the batteries as soon as the power indicator flashes. This will reduce the possibility of false readings. 6. Never attempt to open the unit and perform any repairs this will automatically void the warranty. 7. Do not allow the sensor to come into contact with moisture or acids.
- Page 4 Maintenance Maintenance Information. • The unit may be cleaned using a dry soft cloth, do not use a wet or abrasive cloth, solvents or detergents. Warning. The sensor head should not be removed. Features Accessories. • 2 x AAA batteries (included). •...
-
Page 5: Physical Appearance
Features Physical Appearance. Gas sensor head Detection level indicators High High LED4 LED3 Flexible probe LED2 LED1 Power indicator RAP350 Mini Gas Detector Power Height - 330mm Weight - 50g Width - 40mm (without batteries) Depth - 28mm High High... - Page 6 Measurement Method Instructions for use. 1. Power on. 2. Power indicator light (green) will illuminate, the detection level indicators will illuminate in sequence. 3. This initialisation last approximately 30 seconds. The power indicator light remains on and the unit beeps twice when initialisation is complete.
- Page 7 Measurement Method 8. Hold down the power key for more than 2 seconds to turn off the power supply. Low battery. If the power indicator flashes during use, please replace the battery in order to continue working. Auto power off. If there is no operation or alarm signal the instrument will automatically shut down after approximately 5 minutes.
- Page 8 Battery Replacement Battery Replacement. In order to avoid inaccurate detection readings always replace batteries when the power indicator flashes. When the instrument is not in use for a long time, please remove the batteries to prevent damage caused by leakage. Please replace the batteries by following these steps: 1.
- Page 9 Technical Sensor Gas-sensitive bulk semi-conductor Reactions sensitivity ≥50ppm (methane) Warm-Up time Approx 30 seconds Reaction time ≥2 seconds Operating conditions 0 to 50°C / 20 to 80%RH Storage conditions -10°C to 60°C / 20 to 80%RH Battery life Approx 3 hours Power supply 2 x 1.5 AAA batteries (included)
- Page 10 Limited warranty 1 year warranty against any manufacturing defects or faulty workmanship. This warranty does not cover fuses, disposable batteries or damage from accident, neglect, misuse, alteration, contamination or abnormal conditions of operation or handling. WEEE Directive 2012/19/EU At the end of the product life, dispose of the instrument &...