Advertisement
2001 Chevrolet Corvette
2000-01 AUTOMATIC A/C-HEATER SYSTEMS Corvette
Disconnect negative battery cable. Remove instrument panel grille from instrument panel.
Remove sunload temperature sensor from instrument panel wiring harness and instrument panel
grille. See Fig. 4 . To install, reverse removal procedure.
Fig. 4: Identifying Sunload Temperature Sensor
Courtesy of GENERAL MOTORS CORP.
AIR TEMPERATURE ACTUATORS
CAUTION: DO NOT operate temperature door motor if removed from
HVAC module, damage to motor can result.
Removal & Installation
Disconnect negative battery cable. Remove fuse block cover. Remove right instrument panel trim
panel and air outlet. Remove instrument panel lower right trim panel. Disconnect either
temperature door motor harness connector. Remove either temperature door motor. To install,
reverse removal procedure.
VACUUM/ELECTRIC SOLENOID
Removal & Installation
Disconnect negative battery cable. Remove passenger's floor hush panel. Disconnect
vacuum/electric solenoid electrical and vacuum harness connectors. Remove vacuum/electric
solenoid module mounting screws. Remove vacuum/electric solenoid module. To install, reverse
Advertisement
