Advertisement
12) Remote connector: It is to be connected with remote control box.
13) Torch terminal (+): It is to be linked to the torch terminal of wire feeder.
14)Earth terminal ( ): It should be connected to base metal
4-3.Cautions in handling
1) Torch angle by welding direction Incline the torch 10 15° toward the
welding direction, and afterward you can weld by 'forward method", or
'Backward method" In general, "Forward method' is used considering with
the friction of arc and protection of welded surface by gas.
2) Welding torch
If the welding torch is bent excessively, smooth wire feeding is not available, and welding
condition is damaged due to reduced current. Please do not bend cable forcefully.
3)Standard use rate
5. Safety instruction
1)Power source device : Install one on/off switch for one welder.
2)Terminal connection : Fasten the connection part for smooth current carrying in welding.
3)Ground : Apply class 3 grounding
4)Surrounding environment : Please avoid the location where moisture and dust is too much,
Remote control box
A) Inching: Switch that feeds wire up to the tip of torch at the time of
replacing welding rod
B) Welding voltage: Welding voltage can be adjusted.
C) Welding current: Welding current can be adjusted.
Use rate
60%
70%
80%
90%
100%
Loose fastening may cause cable damage or wasting power.
and surrounding temperature is too high. Select place where air is
ventilated well. Especially, ventilation relates to the use rate.
350C
350A
320A
280A
240A
200A
11
500 C
500A
440A
380A
340A
300A
Advertisement
