Table of Contents
Advertisement
So you may then install your
appliance in a garage or an unheated
room without having to worry about
frozen food in the freezer being
spoilt. However at low ambient
temperatures mentioned above,
fridge contents are likely to freeze,
so check and consume food in the
fridge accordingly. When the ambient
temperature returns to normal, you
may change the setting to suit your
needs.
3. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance
to use more electricity. If installed
next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 50 mm (2")
From Radiators 300 mm (12")
From Freezers 25 mm (1")
4. Make sure that sufficient room
is provided around the appliance to
ensure free air circulation. Fit the two
plastic wall spacers supplied with the
appliance onto the condenser on the
back of the appliance by rotating 1/4
turn (See Diagram).
5. The fridge/freezer should
be located on a smooth surface.
The two front feet can be adjusted
as required. To ensure that your
appliance is standing upright adjust
the two front feet by turning
clockwise or anti-clockwise, until
the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6. Refer to cleaning and care
section to prepare your appliance for
use.
7. A special receptacle is supplied
to store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
WARNING:
Do not locate extension sockets
or
charging
supplies
or
operated products adjacent to the
compressor as they could overheat.
12
EN
transformers/power
Lithium-Iron
battery
Advertisement
Table of Contents
