Table of Contents
Advertisement
Operation Manual / TPR56-F + TPR61-F
6 Removal and installation / 6.2 Removing the turbocharger
6.2.1 TPR56-F/ TPR61-F (without support)
If provided
© Copyright 2018 . All rights reserved.
Disconnect all gas, air and oil pipes in accordance with the engineb-
u
uilder's instructions.
Unscrew the cable connector (86515) on the speed sensor.
u
Inspect the lifting gear.
u
Attach one lifting gear each to the two fins of the bearing casing
u
provided for this purpose.
Loosen the fixing screws (01) at the foot.
u
Remove the sliding blocks (02).
u
WARNING
Beware of tilting
If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Wear personal protective equipment (PPE).
u
Support the turbocharger at a suitable point.
u
Secure with lifting gear wherever possible.
u
Support the turbocharger at a suitable point.
u
Cover the oil connection.
u
HZTL2499_EN
Revision F
December 2018
Advertisement
Table of Contents
