Advertisement
Advertisement
Table of Contents
Summary of Contents for Wet Sounds WW-8CH-LD
- Page 1 WW-8CH-LD 8 Channel Line Driver OWNER’s Manual...
- Page 2 FOR YOU HIGH PERFORMANCE AUDIO SYSTEM The WW-8CH-LD is a device that allows you to expand a 2 channel input into 4 zones of adjustable output and 2 of these zones can be adjusted at anytime using the wired remote.
- Page 3 DIMENSIONS 0.56" 1.00" 1.93" 2.03" 1.20" 5.82" 4.87"...
- Page 4 MOUNTING INSTRUCTIONS REMOTE CUT OUT DIMENSIONS STEP 1: Locate desired location. Please refer to dimensions and check for clearance prior to cutting or drilling. STEP 2: Cut hole using the supplied cut out dimensions. 1.41" STEP 3: Route wires through hole and snap in place. TIP: It is good practice to cut the hole smaller than needed, then enlarge using a le as needed.
- Page 5 WIRING DIAGRAM...
- Page 6 Red light - Signal level is too high SENSITIVITY ADJUSTMENTS For setup, be sure that the output cables of the WW-8CH-LD are disconnected. STEP 1: The sensitivity adjustments are found under a cover plate that is secured in place with three screws. For setup, remove these screws and cover plate.
- Page 7 In the event repair is not possible, Wet Sounds will replace the product in question. If it is deemed necessary Wet Sounds, Inc. will either replace the entire product with a refurbished unit or it will be replaced with a model that is similar in price is that model is no longer available.
- Page 8 Internet Warning Wet Sounds, Inc. products sold on any non- authorized web site or internet auction site are void of any and all manufacturer’s warranty. Please contact Wet Sounds (877-938-7757) or visit our web site (www.wetsounds.com) for a list of authorized online sellers or to...
Need help?
Do you have a question about the WW-8CH-LD and is the answer not in the manual?
Questions and answers