Table of Contents
Advertisement
Appendix C
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 20cm between the radiator & your
body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The availability of some specific channels and/or
operational frequency bands are country dependent
and are firmware programmed at the factory to match
the intended destination. The firmware setting is not
accessible by the end user.
FCC Part 68 Statement
This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among
other information, a product identifier in the format
US: Q87DL01BX2000V2. If requested, this number must be
provided to the telephone company.
The REN is used to determine the number of devices that
may be connected to a telephone line. Excessive RENs on
a telephone line may result in the devices not ringing in
response to an incoming call. In most but not all areas, the
sum of RENs should not exceed five (5.0). To be certain of
the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone
company. For products approved after July 23, 2001,
the REN for this product is part of the product identifier
that has the format US: Q87DL01BX2000V2. The digits
represented by 01are the REN without a decimal point
(e.g., 03 is a REN of 0.3). For earlier products, the REN is
separately shown on the label.
A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed
to be connected to a compatible modular jack that is also
compliant. See installation instructions for details.
If your equipment causes harm to the telephone network,
the telephone company may discontinue your service
temporarily. If possible, they will notify you in advance.
But if advance notice is not practical, you will be notified
as soon as possible. You will be informed of your right to
file a complaint with the FCC. Your telephone company
may make changes in it is facilities, equipment, operations
or procedures that could affect the proper functioning of
your equipment. If they do, you will be notified in advance
to give you an opportunity to maintain uninterrupted
telephone service.
Wireless ADSL2+ Modem Router
Regulatory Information
If you experience trouble with this telephone equipment,
Please contact the following address and phone number
for information on obtaining service or repairs.
The telephone company may ask that you disconnect this
equipment from the network until the problem has been
corrected or until you are sure that the equipment is not
malfunctioning.
This equipment may not be used on coin service provided
by the telephone company. Connection to party lines is
subject to state tariffs.
COMPANY:
Cisco Consumer Products LLC
ADDRESS:
121 Theory , Irvine, Ca., 92617, USA
TEL NO:
1 800-326-7114
Safety Notices
WARNING:
To reduce the risk of fire, use only
No.26 AWG or larger telecommunication line
cord.
WARNING:
Do not use this product near water,
for example, in a wet basement or near a
swimming pool.
WARNING:
Avoid using this product during an
electrical storm. There may be a remote risk of
electric shock from lightning.
WARNING:
This equipment will be inoperable
when main power fails.
WARNING:
To
explosure limits to radiofrequency fields, the
antenna of the device should be no closer than
20 cm from the body during use.
ensure
compliance
with
19
Advertisement
Table of Contents
