Moller Medical mask4all Instructions

Contents: Large clip (2x)
MöllerMedical
Front
Back
1. Fold fi lter fabric
Fold the narrow areas close to the top and bottom edges of
the fabric towards the middle, so that the edges are parallel.

2. Placement of holding clips

Lay the larger plastic parts under the fabric, with the "Möller
Medical" logo facing downwards and the holes towards the
outer edges. Place the smaller plastic parts, one on each side,
near the edges of the fabric. The back / the ridges on the clip
should face upwards, away from the fabric surface.

3. Closing the holding clips

Clip the plastic parts together through the fabric by pressing
until it is fi xed between the two parts. The fabric is pushed
down into the large part. Repeat at the other end of the
mask.
Small clip
Filter fabric
Large clip

4. Attaching holding bands

Attach the enclosed elastic bands through
the holes at the sides of the larger plastic
parts. These can be used to fi x the mask
securely over your ears.
When you put on the mask4all, fold out the
edges of the fabric over nose and throat (see
drawing), to cover your nose and chin.

5. All done!

Now you can wear your self-assembled
mask4all. Should the mask be too tight or too
loose, the clips can be loosened and repositio-
ned. Manual stretching of the elastic bands
before attaching / before wearing may also
help to improve the fi t.
Möller Medical GmbH
Wasserkuppenstr. 29-31
36043 Fulda, Germany
Instructions
Small clip (2x)
(schematic)
Video tutorial:
www.mask-4-all.de
Filter fabric (3x)
Small fold for nose area
Large fold for chin area
Holder bands (2x)