Summary of Contents for Imagineering Clubs MORSE KEY & BUZZER Mk 2
Page 1
MORSE KEY & BUZZER Mk 2 Instructions The Finished Model The model should look like this when it is finished. The important parts are shown in the picture. Topics Covered Electromagnetism, Conductors and Insulators, Electrical circuits, Fundamentals of telecommunication. Tools required One 7mm and two 13mm open ended spanners.
Page 3
2. d ) Fit the coil assembly (armature) to the 2. b ) Leaving about 8 cm of the copper wire base with a washer each side of the bracket, free so that it can be connected to the tightened with the second nut. terminals, wind all the wire onto the spacers as neatly as possible.
Page 4
Put another washer and nut on terminal C, connect the other end of the 10cm wire to it and tighten it down. Bend the key strip up slightly so that it is just clear of the Key screw. 1mm gap Key Strip Armature Screw...