Advertisement
LCX Series
Models: LCX-OCC
Time setting
The light can be set to stay ON for any period of time between approx. lOsec (dial rotate fully counter
clockwise) and a maximum of 30min(dial rotate fully clockwise). Any movement detected during the "on"
time will reset the timer. The LED indicator will flash when adjusting the time setting dial. The number of
flashes means the following: 1 flash = 5 sec, 2 flashes= 15sec, 3 flashes= 30 sec, 4 flashes= 1 min,5 flashes=2
min, 6 flashes= 4 min, 7 flashes= 6 min, 8 flashes= 8 min, 9 flashes=lO min, 10 flashes=12min.
NOTE: After the light switches off, it takes approx. 1sec before it is able to start detecting movement again.
The light will only switch on in response to movement once this period has elapsed.
Light-control setting
The chosen light response threshold can be infinitely from approx. 2-2000Iux. Turn it fully counter
clockwise to select dusk- to-dawn operation at about 2 Lux. Turn it fully clockwise to select daylight
operation at about 2000lux. The knob must be turned fully clockwise when adjusting the detection zone and
performing the walk test in daylight. Note: This feature is disabled with the unit.
Troubleshootina
Malfunction
Cause
The load will not work
• wrong light-control setting selected
• load faulty
• mains switch OFF
The load work always
• continuous movement in the detection zone
The load work without any
• the sensor not mounted for detecting
identifiable movement
movement reliably
• movement occurred, but not identified by
the sensor(movement behind wall, movement
of a small object in immediate lamp vicinity
etc.)
The load will not work
• rapid movements are being suppressed to
despite movement
minimize malfunctioning or the detection zone
you have set is too small
COMPATIBLE
UNDERCABINET PRODUCTS:
SLATE
PRO,
NOBLE
PRO,
NOBLE,
T5l,
AND
NXL
INCLUDED
WITH
MOTION SENSOR
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used ooder normal operating
conditions for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of
defective fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
/\F)C
Page 3 of3
2345
N.
Microwave Motion Sensor
Remedy
• Adjust setting
• Change load
• Switch ON
• check zone setting
• securely mount enclosure
• Check zone setting
• Check zone setting
MICROWAVE
SENSOR
AC
INPUT
POWER CORD
WITH QUICK CONNECT SUPPLY
WITH
UNDERCABINET
PRODUCTS LISTED
Ernie Krueger Circle Waukegan, IL 60087
8060723 RI
Advertisement
